ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
272
NOTE:
If more then one binary input for MinRunPower is activated, the one with the
highest number is used (i.e. its corresponding value).
CAUTION!
All controllers cooperating together in Power management must have the same
minimal running power selected.
NOTE:
It is possible to use virtual peripheries for distribution of the binary signal from one
physical switch connected to one controller to all other controllers over the CAN
bus. See the principial diagram of such distribution in the description of the input
Load res 2.
Binary input: MinRun power 3
Related FW
3.0
Description
This input is used to activate the function Minimal running power #3, which is
adjusted by setpoint #MinRunPower 3.
NOTE:
The default value of minimal running power, which takes place while none of the
inputs MinRun power x, is 0kW.
NOTE:
If more then one binary input for MinRunPower is activated, the one with the
highest number is used (i.e. its corresponding value).
CAUTION!
All controllers cooperating together in Power management must have the same
minimal running power selected.
NOTE:
It is possible to use virtual peripheries for distribution of the binary signal from one
physical switch connected to one controller to all other controllers over the CAN
bus. See the principial diagram of such distribution in the description of the input
Load res 2.
Binary input: Priority sw A
Related FW
3.0
Description
This is one of four inputs Priority sw A, Priority sw B, Priority sw C and Priority sw
D that can be used for selection of the power management priority externally.
These inputs are optional and if not configured, the priority is then adjusted by the
setpoint Priority.
ENCODING TABLE
PRIORITY
INPUT A
INPUT B
INPUT C
INPUT D
Default
0
0
0
0
1
1
0
0
0
2
0
1
0
0
3
1
1
0
0

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English