DX-80 HARD DRIVE VOICE MAIL INSTALLATION AND SUPERVISOR GUIDE 09/01
19
Note: If a connection cannot be established between the host (Voice Mail) and the
remote PC, verify that you specified the appropriate COM port settings
during Serial Administration / KeyLink installation. Also verify that you are
using a Straight through cable.
Note: It is important to note that the Windows interface to the Voice Mail is based
on a version of VP system software, and for this reason, the Windows
interface Help menu contains the information provided with VP systems.
Note: Some Serial Administrator windows will not fit screens using a resolution of
less than 800 x 600.
2.4.3 Setting up the System
Because the integration parameters are pre-set before the Voice Mail leaves the factory, once
you access the Voice Mail using a laptop computer, you are ready to begin customizing the
system. Customizing the system involves:
• Specifying System Information
• Specifying Routing Box and Mailbox Information
2.4.4 Specifying System Information
System Information screens contain system setup information that applies system-wide, to all
boxes set up on the system. There are six System Information screens:
• General Information Screen
• Line Information Screen
• Business Hours Screen
• Call Transfer Screen
• Class of Service Screen(s)
• Other Customizations Screen
Before you set up Routing boxes and mailboxes, it is best to ensure all System Information
screens are properly completed.
To Next Page