DX-80 HARD DRIVE VOICE MAIL INSTALLATION AND SUPERVISOR GUIDE 09/01
85
2.6.3 Using the Teleparameter Feature to Adjust the System
Setup
You can use the Teleparameter feature to adjust the system setup at any time. It is not
necessary to bring down the system to make modifications. To use the Teleparameter feature
to adjust information, follow steps 1 through 4 in the procedure in section 2.6.1. For specific
parameters you can adjust, refer to section 2.6.1.
Note: If you enter a parameter number for a parameter that affects a particular
box, the system prompts you to enter the Item number. The Item number
identifies the particular box in which you want to change the parameter. At
the Item number prompt, enter the number of the box.
Be advised that many day-to-day modifications that must be made to the system (adding
mailboxes, changing system greetings, making call routing modifications) can be done by
calling into the supervisor mailbox and selecting options from the Supervisor menu. By
using Supervisor menu options, you do not need to refer to specific parameter numbers and
values. For information on day-to-day modifications that can be made using Supervisor
menu options (and not the Teleparameter feature), refer to section 3.
To Next Page
Loading...
