DX-80 HARD DRIVE VOICE MAIL INSTALLATION AND SUPERVISOR GUIDE 09/01
51
3. The system voices the Main menu:
“To listen to your messages press 1. To send a message press 2. To change your options
press 3.”
4. To access the Supervisor menu, press 6 (this option is not voiced). The system voices
the Supervisor menu options:
5. From the Supervisors menu, press 9 to modify system parameters. The system prompts
you to enter the Technician password. By default, this password is 1234.
6. At the prompt, enter the number of the parameter you want to change, then, as prompted,
the value to which you want to change the parameter. Parameter information is provided
in a comprehensive table shown in section 2.6.2.
When you complete all modifications, press # to return to the Supervisor’s menu.
Note: Refer to section 2.6.2 for information on values you can specify for certain
parameters and for information on adjusting parameters in the VM.CFG file.
2.6.1.3 Adjusting Routing Box Information
As indicated in section 2.4.5.2, you need to adjust Routing Boxes 800, 801, and 821 to
include any single-digit call routing options you want to provide to callers. You must also
Supervisor Menu
For Mailbox Administration Press 1
For Routing Box Administration Press 2
For Question Box Administration Press 3
For Port Administration Press 4
To Change the System Broadcast Message Press 5
To Change the Voice Mail Day / Night Service Press 6
To Change the System Time Press 7
To Change the System Date Press 8
To Modify System Parameters Press 9
To Next Page
Loading...
