Comelit IP START Series - DDNS Settings; NTP Settings; Email Settings

18
12) Alarm host IP: input the IP address of the alarm host.
13) "Alarm host port": input the port No. of the alarm host.
14) "Enable PPPOE" : check it to enable this feature.
·Input PPPOE user name.
·Input device dynamic address.
·Input PPPOE password.
·Confirm password.
15) Enable UPNP: if it is enabled, device port and HTTP port will automatically be mapped into the router.
4.3.2 DDNS Settings
DDNS is implemented through a dynamic domain resolution server. It requires a PC with fixed IP address on the
Internet, on which the dynamic domain resolution server runs.
1) Select DDNS server type (Ipserver, Dyndns, PeanutHull and 3322, currently, only 3322 is supported)
2) Input server name, for example, member.3322.org
3) Input port No.
4) Input user name.
5) Input password.
6) Confirm password.
7) Input spare domain.
4.3.3 NTP Settings
1) Input server address: IP address of NTP server.
2) NTP port: only TCP transmission is supported by SNTP. The port number is 123 by default.
3) Synchronize every: input the time interval to be adjusted.
4) Select time zone: optional time zone.
5) GMT: fine tune the time.
4.3.4 Email Settings