Gas detector
Delete gas detector
Registering a gas leak alarm
1)
Press the button for about 10-13 seconds (located
on the top of the product)
2)
Release the LED when it is blinking.
3)
Upon successful completion, the message ”Device
has been deleted” is displayed on the wall pad.
1)
Press '+'
2)
Shown ”ADD Device..”
3)
Press the button for about 10-13 seconds (located
on the top of the product)
4)
Release the flashing LED. Press the button once.
5)
When registration is completed normally, ”Device
registered” message is displayed.
To Next Page
Loading...
