Commodore MPS-801 - Cleaning; Lubrication

CLEANING
Due to its material, each part has its own proper cleaning liquid and method. It should be noted that
if an improper cleaning liquid is used or the cleaning method is incorrect, parts may be damaged or
may not function properly. Follow the instructions in Table 1 to clean.
PARTS
CLEANING
METHOD
CLEANING
OIL
REMARKS
Metal parts Brush washing Benzine
Plastic
parts of Brush washing
Benzine
• Do
not use any liquid other
the Mechanisms
than the one designated.
• Wash quickly, wipe with a
cloth and dry rapidly.
• Use good quality clean
liquids.
Plastic
parts of
- -
Wipe off dirt.
the enclosure
Rubber parts
- -
Wipe off dirt.
Electrical parts Do not wash
Wipe off dirt with a cloth
dampened with benzine or
alcohol.
CAUTION: CLEANING FLUIDS ARE FLAMMABLE. Keep away from heat. Air dry ONLY, prior to
re-insta Ilation.
LUBRICATION
NOTE - Be sure that all points requiring lubrication are thoroughly cleaned before beginning.
Lubricate out of warranty units when service is required using a light spray oil. CRC or WD40 will
do fine but be careful not to use a product that will attract and hold dust and dirt.
SEE SECTION 2 and 5 of MECHANICAL ASSEMBLIES (pages 27 and 29) for LUBRICATION POINTS.
11