CommScope CMC-21 - Section 2. CMC Cabinet Concrete Pad Installation; Step 1. Remove Packaging, Prepare Cabinet for Installation

Material ID 860647713
Rev B, V.05, February 2022
Page 11
38 Pages
Section 2. CMC Cabinet Concrete Pad Installation
► Step 1. Remove Packaging, Prepare Cabinet for Installation
Caution:
Observe the following to prevent damage to the cabinet.
■ Do not accept the cabinet from the shipper if the packaging appears damaged.
■ Only remove the packaging and pallet at the installation site.
■ Properly strap cabinet to a truck or trailer to prevent shifting, and always transport and store
cabinet in an upright position.
■ If using a dolly, make sure a side of the cabinet without a removable panel faces the dolly. Do
not tilt the cabinet more than 30º from vertical when moving the cabinet.
■ Use a forklift or the cabinet lifting brackets to raise and move the cabinet. Make sure the forklift
tines are at least four feet long and check for correct installation of the cabinet lifting brackets
beforehand.
■ Do not remove the cabinet from pallet and open the door, cabinet tip-over may occur causing
injury to field personnel.
To prepare cabinet for installation:
1. Remove all shipping material and the door key from the cabinet.
Note: The cabinet contains desiccant bags inside to reduce moisture. Until service turn-up, keep
bags inside cabinet. Activate a low power heat source (a 60 W light) for humidity control if
you do not place cabinet in service after installation.
2. Open door with door key, remove the installation kit, and close the door, Figure 3.
Note: Retain the pad gasket set between pallet and cabinet (required installation), Figure 14.
Table E: CMC-21 Cabinet Installation Kit (860463686)
Item
Qty
Description
1
1
Door Key
2
6
Shim
3
6
Screw, Hex HD 1/2-13 X 1.50 SS
4
6
Washer, Lock, 1/2", SS
5
6
Rubber Washer
6
6
Washer, Flat 1/2, A-153
7
1
Plastic Bag
Figure 11. Cabinet Installation Kit 860463686