M300 Pro GNSS Receiver User Guide
External Memory: If set as external memory without inserting a USB drive, it
will be prompted with a message that “please connect to an external
memory”.
Show record name, status, data format, record mode and operation in table,
click Setting button to configure the data recording settings.
CAUTION - Please be careful to click the Format Disk button. It will empty all your data files in
M300Pro.
To configure the data recording settings, please make sure that recording mode is on
manual with unrecorded status.
Setting options are showed below:
Record Name: Support only number or letter
Storage Option: Choose storage location to internal memory or external
memory
Sample Interval: Choose sample frequency, support0.05\0.1\0.2\0.5\1\2\5
\15\30\60 S.
File Split: Choose file split, support every 5\10\15\20\30 minutes or 1\2\4\24
hours to save a file. If you select 24 as file split, it will create two data file
when it occur to 24 o'clock (UTC Time). One is from start time to 24 o’clock,
another is from 0 o’clock to end time.
Data Format: Support CNB\BINEX\Rinex3.02\Rinex2.10(excluding BeiDou)
Loop: When storage is full, Yes means delete earliest data and store
continually, No means stop recording
Storage Space: Separate storage space in internal memory\external memory
Mode: Support manually and automatically recording mode.
To Next Page
Loading...
