ComNav SinoGNSS M300 Pro - Frequently Used Commands

M300 Pro GNSS Receiver User Guide
31
5.1 Frequently used commands
 Check Version Information
log version // Version information about the board
 Check Port Information
log com configa // Information of the port.
 Change the serial port baud rate
com com1 9600// Change the baud rate of com1 to 9600
 Check System Information
log sysconfiga //All the configuration of the system can be viewed by this
command.
 Check the Output data Information
log loglista//View the output data information about all the ports.