Compaq Service Reference Guide F-7
Hard Drive
The information provided by the diagnostics tests includes: error code, system serial number,
drive serial number, drive model, and drive firmware revision. Specific details of the drive failure
are not included.
When you run the diagnostics, the test results are stored in a log. After completing the test, you
can print this log to a local printer or save it to a file. Alternatively, before running the test, you
can configure the test options to send the results to a local printer or file.
Problem Possible Solution
Hard drive error occurs. Hard disk has bad sectors or has failed. Use a utility to locate and
block usage of bad sectors. If necessary, reformat the hard disk.
Disk transaction problem. Either the directory structure is bad or there is a problem with a file. In
Windows 95 and 98, run ScanDisk. Click Start
#
Programs
#
Accessories
#
System Tools
#
ScanDisk.
In Windows NT, right click Start, click Explore, and select a drive.
Select File
#
Properties
#
Tools. Under Error-checking, click Check
Now.
Drive not found (identified). 1. Cable could be loose. Check cable connections.
2. The system may not have automatically recognized a newly
installed device. See reconfiguration directions in the Hardware
Installation Problems section. If system still does not recognize the
new device, check to see if the device is listed within Computer
Setup. If it is listed, the probable cause is a driver problem. If it is not
listed, the probable cause is a hardware problem.
3. Check drive jumper settings. If the drive is a secondary drive that
has just been installed on the same controller as the primary drive,
verify that the jumpers for both drives are set correctly.
4. Check SCSI IDs to ensure none are duplicated.
Nonsystem disk message. 1. The system is trying to start from a diskette that is not bootable.
Remove the diskette from the diskette drive.
2. The system is trying to start from the hard drive but the hard drive
may have been damaged. Insert a bootable diskette into the diskette
drive and restart the computer.
3. Diskette boot has been disabled in Computer Setup. Run Computer
Setup and enable diskette boot.
Second Ultra ATA hard drive does
not perform optimally.
The cable is not compatible with the drive type. Reinstall the second
Ultra ATA hard drive using an 80-conductor cable.
To Next Page
Loading...
Need help?
General