Chapter 5 Access to Web Interface
14
Chapter 5 Access to Web Interface
This chapter explains the basic set up procedures of configuring Compex SXP2224WM using
web-based interface.
5.1 Configuration on PC settings
Each PC in the LAN must be configured in order for them to communicate with
Compex SXP2224WM. Please follow the steps as shown below:
1. From your Windows 95/98/2000/NT/ME/XP computer, click “Start” button,
point to Settings, and select Control Panel.
2. Double click the Network icon.
3. Check to see if the TCP/IP protocol is installed. If not yet, please add this
protocol first before proceeding with the next step.
4. Select TCP/IP protocol and click “Properties” button. Click on the radio
button for Specify an IP address and key in the IP Address and Subnet Mask as
192.168.100.xxx and 255.255.255.0 respectively, where xxx can be any number
from 1 to 254 except 128.
5. Hit the “Ok” button and restart your computer.
To Next Page
Loading...
