Compool Cp3000
13
leads to about 6”. Do not strip wires. Push the 2 wires to be connected into the small holes at one end of the
connector, and squeeze the connector with a pair of pliers. 2 extra connectors are included.
5. At the Lx3000, connect Sensor cable to circuit board at WTS- and WTS+ Screw Terminals in accordance with
wiring diagram located inside Lx3000 door. Pay attention to color-coding of wires (green wire connects to
WTS- and red wire connects to WTS+).
Note: Infield calibration of temperature sensor(s) is required. See CALIBRATING TEMPERATURE SENSORS for
details.
Installation
To Next Page
Loading...
