Compool Cp3000
32
Note: The Control System must be in “Auto” mode to enable this feature.
To turn the filter pump on, press Key #P (Filter Pump) 2 times quickly. The “Auto” mode Status Lamp will begin to
blink, and the Filter Pump Status Lamp will illuminate for the 3-Hour cycle.
To turn the filter pump off, press Key #P (Filter Pump) 3 times quickly. The “Auto” mode Status Lamp will begin to
blink, and the Filter Pump Status Lamp will not be illuminated during the 3-Hour cycle.
To cancel this 3-Hour cycle from the Lx3000 Power Center, press Auto/Service Key to “Service” mode, and then back
to “Auto” mode.
VALVE ACTUATORS
Your control system is designed to actuate two motorized valves, which automatically rotate between pool and spa
circulation whenever the Spa is activated. A motorized valve may also be used to automatically divert the flow of
water through your solar panels (if applicable) whenever solar energy is available.
These Valve Actuators are also activated by the Spa/Fill/Drain and Solar Equipment Service Keys at the Lx3000
Power Center. Your system may also include additional motorized valves for hydraulic applications, such as a
fountain, waterfall, or pool cleaner.
SPA-SIDE REMOTE
One or more 4-button waterproof Remote Controls may be located at your spa. This will enable you to override the
Cp3000 Controller, and manually activate your spa equipment from the convenience of the spa.
Operating Instructions
To Next Page
Loading...
