Compool Cp3000
19
SYSTEM START-UP
1. Turn system power on.
2. At the heater, make sure that the switch is turned to the ON, High or Spa position, and that the temperature dial is
turned to the highest setting.
3. At the Lx3000 Power Center, press the Auto/Service Key to switch the System to “Service” mode. Press the #S
Key to Spa mode, and check that Valve Actuators have rotated to spa positions. If either valve is 180° out of
phase, flip toggle switch on rear of Valve Actuator from ON1 to ON2 position.
4. Press the remaining Equipment Service Keys (#P, #1, #2, #3, #4, #5 and #6) to verify that corresponding
equipment is being activated.
5. Press the Heater Key, and verify that the heater is firing (filter pump must be on and pumping).
6. If solar system is installed, verify program switch on the Lx3000 circuit board SOLAR is in the ON position.
The Cp3000 system will only recognize the solar installation if this switch is ON (see SOLAR SENSOR for
details).
7. Press the Solar Key, and check that the Solar Valve (if applicable) has rotated to solar position. If it is 180° out of
phase, flip toggle switch on rear of Valve Actuator from ON1 to ON2 position.
8. Check that neither Temperature Sensor Status lamps are illuminated. If a lamp has turned on, check wiring
connections to the appropriate Sensor.
9. After the equipment operation has been tested from the Lx3000, press Auto/Service Key to return System to
“Auto” mode.
10. At the Cp3000 Controller, press each Equipment Key (#S, #P, #1, #2, #3 and #4), and check that appropriate
equipment is being activated. Note: If the Auto/Service Key at the Lx3000 has inadvertently been left in the
“Service” mode, the Service status lamp will illuminate at the Cp3000 Controller.
11. A set of adhesive labels is provided for custom identification of individual circuits. Use a pair of fine-tip
tweezers to adhere the appropriate label adjacent to the Equipment Key at the Cp3000 Controller and Lx3000
Power Center. A set of labels is also provided for custom identification of the buttons at the optional Spa-Side
Remote.
Installation
To Next Page
Loading...
