Computherm E300 - Connecting to Electrical Network; Mounting the Thermostat

- 17 -
and L of the terminal block located on the rear side of the thermos-
tat. You do not have to take care of phase correctness during the
connection process.
6.4.Mountingthethermostat
To install the thermostat you should separate the front plate from
the black plate. To do so, slide the front plate of the thermostat
upwards and slide the rear part of the product downwards at the
same time (Figure 6). Following this, place the rear part of the
product into the electric wall mount box then secure it by screws
(Figure7). Finally, slide back the front plate of the product into the
black plate.
Figure 6 Figure 7