Comtec ZDR-024CE - Page 15

15
Installation
method
2 ) Clean the mounting stay and windshield with the attached degreasing
cleaner. After drying them, use double-sided adhesive tape to stick the
mounting stay to the windshield.
Advice
• When sticking the stay, start sticking it from one side little
by little in order to achieve proper adhesion with less air
bubbles.
* Sticking the stay in one go allows air bubbles to get in, leading
to easy detachment of the stay.
• Firmly press the stay on the back side of the sticking face by hand to avoid uneven
adhesion. In addition, check that the sticking face is even by looking at it from the
outside of the vehicle after sticking it.
Press the sticking
face of the stay from
th b k id
Check from the
outside of the vehicle
th t th i
◇
Stay sticking face
Sticking entirely
Bubbles and color
unevenness found
S
ticking entirel
y
B
u
b
bl
es an
d
co
l
or
unevenness
f
oun
d
Stick it from one
side, little by little
Installation method