EasyManua.ls Logo

Comtec ZDR-024CE - Page 16

Comtec ZDR-024CE
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
Caution
Install the product so as not to obstruct the functions of the vehicle (airbags,
HWF)DLOXUHWRGRVRPD\FDXVHDQDFFLGHQWDQGLQMXU\
7KHUHDUHVRPHFDVHVVWLFNLQJLVGLႈFXOWGHSHQGLQJRQWKHVKDSHDQGPDWHULDO
RIWKHGDVKERDUG,QDGGLWLRQFDUHLVUHTXLUHGZKHQSHHOLQJRႇWKHGRXEOHVLG-
ed adhesive tape because the sticking face may be damaged due to aging
deterioration. If such a situation can be anticipated, install the product to the
windshield of the back side of the rearview mirror.
Always check the following details. Failure to check them may cause
SHHOLQJRႇ
Make sure you clean any stains (oil, water drops, etc.) on the sticking face and the mounting stay with the included
cleaner. Install the product after drying them.Do not use a parts cleaner and glass cleaner, etc. Doing so may
FDXVHSHHOLQJRႇ
When using a shade such as a sunshade, be careful not to place the main unit between the windshield and the
VXQVKDGH'RLQJVRFDQFDXVHKHDWWRHDVLO\DFFXPXODWHDQGPD\FDXVHWKHGRXEOHVLGHGDGKHVLYHWDSHWRSHHORႇ
The adhesive power of the double-sided tape will become weak when the air temperature is extremely low. Warm up
the adhesive face with a dryer, etc. to attach the product. Also, be careful not to allow the heat of the dryer to come
into direct contact with the product.
Do not reuse the double-sided adhesive tape because the adhesive power of the used tape becomes weak.
Be careful not to pull nor apply unreasonable pressure to the product after installing it until the double-sided adhe-
VLYHWDSHLV¿UPO\DGKHUHG)DLOXUHWRGRVRPD\FDXVHWKHSURGXFWWRFRPHRႇ
7KHSURGXFWPD\FRPHRႇZKHQWKHFHQWHUVHFWLRQRIWKHGRXEOHVLGHGDGKHVLYHWDSHLVQRWDGKHUHGRUZKHQDOORI
the double-sided tape is not adhered to the windshield or the dashboard.
3
) Arrange the wiring of the cigar plug cord.
* Use a commercial cord clamp, etc. to arrange the
wiring in order to avoid interference with driving.
* Do not bundle the cords for terrestrial digital broad
-
casting and ETC, etc. together.
Push in
Cigar plug cord
Commercially
available cord
clamps, etc.
Installation method