Comtech EF Data UT-4505 - TPE (Time Protocol Enable); TPS (Time Protocol Server); LRS (Local; Remote Status)

UT-4500 Series C- and Ku-Band Up Converters MN/UT4500.IOM
Serial Interface Operation Revision 3
8–12
8.7.2.3 TPE (Time Protocol Enable)
Use TPE to set or return the Time Protocol.
Description
Details
Set Time Protocol:
<DEV/TPE_x{cr} where:
x=0 Time protocol disabled
1 Time protocol enabled
Confirmation:
>DEV/TPE_x{cr}{lf}]
Return TPE:
<DEV/TPE_{cr}
Confirmation:
>DEV/TPE_x{cr}{lf}]
8.7.2.4 TPS (Time Protocol Server)
Use TPS to set or return the Time Server IP address for the rear panel ‘Ethernet’
M&C port.
Description
Details
Set Time Protocol Server:
<DEV/TPS_xxx.xxx.xxx.xxx{cr} where:
xxx.xxx.xxx.xxx is the Time server IP address.
Confirmation:
>DEV/TPS_xxx.xxx.xxx.xxx{cr}{lf}]
Return TPS:
<DEV/TPS_{cr}
Confirmation:
>DEV/TPS_xxx.xxx.xxx.xxx{cr}{lf}]
8.7.2.5 LRS (Local / Remote Status)
Use LRS to enable or disable remote communications interfaces. The factory
default setting is “3” (Ethernet+Serial remote control enabled).
Description
Details
Set Local / Remote Status:
<DEV/LRS_x{cr} where:
x=0 LOCAL mode (front panel control only, remote control disabled)
1 Serial remote mode
2 Ethernet remote mode
3 Ethernet+Serial remote mode
Description LRS:
>DEV/LRS_x{cr}{lf}]
Return LRS:
<DEV/LRS_{cr}
Confirmation:
>DEV/LRS_x{cr}{lf}]