3
7. Wear a face shield or safety eye glasses and
inspection glove when handling the lamp
assembly.
8. Do not leave fingerprints or any other
residue on the lamp reflector surface or the
bulb.
9. Do not subject the lamp to mechanical
forces or rough handling that may fracture
the lamp as this may result in an explosion.
10. Do not operate the light source with
suspected failures. If you suspect there is
damage to this product, have it inspected by
qualified personnel.
11. Do not block ventilation slots or openings
— provide at least four inches of free air
space between the sides of the light source
and any hard surface.
1.2.4 Unplug the device from the wall
outlet if any of the following
occur:
1. The power cord is damaged.
2. Liquid has been spilled on the device or it
has been exposed to other moisture.
3. The device has been dropped or damaged in
any way.
4. The product displays a distinct change in
performance.
5. The product does not operate properly
when the operating instructions are
followed.
1.3 Receiving Inspection
Upon receipt, carefully unpack the light source
and accessories. Ensure all items listed below
are included in the box and are free from
damage. If any damage is noted contact your
ConMed Linvatec Customer Service. Save
ALL
packaging materials; they may be needed to
verify any claims of damage by the shipper.
• LS7700 Xenon Light Source:
The power cord is sold separately and is
packaged in a separate box.
• C7104 Power Cord — 115VAC
• C7105 Power Cord — 230VAC
To Next Page
Loading...
