ConMed LS7700 - Page 23

9
• The OLED displays “BRIGHTNESS”
via a bar graph in increments of 5%.
• The BRIGHTNESS Up Arrow
increases brightness in increments
of 5%.
• The BRIGHTNESS Down Arrow
decreases brightness in increments
of 5%.
• The STAND-BY button returns the
light source to STAND-BY mode. The
POWER button turns the light source
off.
4. Light Source ON, Auto Shutter Control:
• To enable Auto Shutter control, the
ethernet cable must be connected
between an IM4000 series ConMed
Linvatec camera and the light source.
• The IM4000 series camera head button
can enable or disable the STAND-BY
mode.
4a When STAND-BY mode is enabled:
• OLED displays “STAND-BY” and
remaining lamp life hours.
• The BRIGHTNESS buttons are
inactive. The POWER button will
turn the light source OFF. The
STAND-BY button returns the light
source to Auto Shutter mode.
4b. When STAND-BY mode is disabled:
• The BRIGHTNESS buttons are
controlled by the IM4000 series
camera to achieve the desired picture
brightness.
• The STAND-BY button returns the
light source to STAND-BY mode.
The POWER button will turn the
light source OFF.
5. Lamp Life:
• When the light source is in the ON
condition and the STAND-BY mode is
enabled, the OLED displays lamp life
hours remaining, beginning at 500
hours and counting down to zero in
increments of one hour.
• When lamp life is 10 hours or less, the
OLED displays a blinking message to
indicate nearing end of life or at end of
life.
6. Lamp Replacement:
• For installation instructions see “3.3
Lamp Replacement” on page 10 .
• Replace only with ConMed Linvatec
Lamps. Use of unauthorized lamps will
void certifications and/or warranties
and may affect safety and performance.
7. Lamp Door Open:
• Lamp door must be closed for unit to
operate.
8. Lamp Saver:
• If light source is in STAND-BY mode,
continuously for one hour, the light
source lamp will turn off. When
STAND-BY mode is disabled, the
lamp will turn on and the light source
will return to normal operation.