Contour NEXT User Manual

12 13
Contour
®
next blood glucose monitoring system
TESTING
1. Remove the endcap from the lancing device.
2. Loosen the round protective
cap on a lancet by rotating the
cap ¼ turn, but do not remove
the cap.
3. Insert the lancet rmly into the
lancing device until the lancet
comes to a complete stop.
4. Twist o the round protective
lancet cap. Save the cap for
disposing of the used lancet.
5. Replace the endcap.
6. Rotate the endcap dial to adjust
the puncture depth.
The amount of pressure applied
to the puncture site also aects
puncture depth.
Insert the Test Strip
1. Remove a Contour next test
strip from the bottle.
2. Tightly close the bottle lid
immediately after you have
removed the test strip.
CAUTION: Do not use expired materials. Using expired material can
cause inaccurate results. Always check the expiration dates on your
test materials.

Contour NEXT Specifications

General

Sample Size	0.6 µL
Testing Time	5 seconds
Memory Capacity	800 test results
Coding	No coding required
Power Source	Battery
Measuring Range	10 to 600 mg/dL
Battery	CR2032
Dimensions	77 x 57 x 19 mm
Weight	47.5 g
Operating Conditions	5°C to 45°C
Storage Conditions	-20°C