Contrec 212 - Page 46

212-M-V2.1
44 Set-up Mode
Parameter Value Description
If High and Low alarms are installed:
13. REL0 Flw H
Flw L
Pwr H
Pwr L
∆t°H
∆t°L
Ft° H
Ft° L
Rt° H
Rt° L
Defines the parameter for Relay 0
output as being high or low alarm for
flow, power, temperature difference,
feed or return temperatures.
14. REL0 xxxx.xxx Set point for parameters set in step
13 above. For low alarms the relay
will close if the parameter is below
the set point.
For high alarms it will close if the
parameter is above the set point.
15. REL1 ... Defines the parameter for Relay 1 as
in step 13 above.
16. REL1 xxxx.xxx Set point for parameter for Relay 1 as
in step 14 above.
If 4-20mA Output is installed:
13. 4-20mA Flow
Pwr
∆t°
Ft°
Rt°
Defines the parameter to be output
as a
4-20mA signal.
14. 4mA xxxx.xxx Flowrate or temperature which
corresponds to 4mA.