Control Microsystems SCADAPack LP - Counter Inputs

Problem Action
Output LED and output are
off when they should be on.
Check that the output is not forced off.
The LED is dim. This normal operation when the controller is in
sleep mode.
13.5 Counter Inputs
Problem Action
Input LED does not come
on when input signal is
applied.
Check the input signal at the termination block. It
should be at least 50% of the counter input range.
The LED is dim. This normal operation when the controller is in low
power mode or sleep mode.
SCADAPack LP Hardware Manual
May 26, 2006
40