CF3000 - USER MANUAL
9
Detectors
Analogue Photoelectric Detector - CAP320
This is the most commonly used detector and is
most suitable for detecting slow burning fires. The
status LED can be programmed to either be
permanently off under normal conditions or to
pulse in order to confirm that it is in
communication with the CF3000 control panel.
Analogue Photo/thermal Detector - CAPT340
This is a new addition to the Cooper range of
detectors. It is the ideal detector for a multi-use
environment as it has an excellent response to
smouldering and fast burning fires. Photo/thermal
detectors can be programmed for thermal only
operation at certain times of day. The status LED
can be programmed to either be permanently off
under normal conditions or to pulse in order to
confirm that it is in communication with the
CF3000 control panel.
Analogue Heat Detector - CAH330
Heat detectors are suitable for dusty environments
or environments where smoke is likely to be
present under normal operating conditions. The
CAH330 can be programmed to operate in A1R,
BS or CS mode of operation depending on the
required application and sensitivity requirements.
The status LED can be programmed to either be
permanently off under normal conditions or to
pulse in order to confirm that it is in
communication with the CF3000 control panel.
Section 1 - System Installation and Design
To Next Page
Loading...
