Copley Controls Corp. 8
ABOUT THIS MANUAL
Overview and Scope
This manual describes the operation and installation of the Xenus amplifier manufactured by
Copley Controls Corporation.
Related Documentation
Users of the CANopen features should also read these Copley Controls documents:
• CANopen Programmer’s Manual
• CML Reference Manual
• Copley Motion Objects Programmer’s Guide
Also of related interest:
• Copley Indexer Program User’s Guide (describes use of Indexer Program to create motion
control sequences)
• Copley Controls ASCII RS-232 User Guide (describes how to send ASCII format commands
over an amplifier’s serial bus to set up and control one or more amplifiers)
Information on Copley Controls Software can be found at:
http://www.copleycontrols.com/Motion/Products/Software/index.html
Comments
Copley Controls Corporation welcomes your comments on this manual. See
http://www.copleycontrols.com for contact information.
Copyrights
No part of this document may be reproduced in any form or by any means, electronic or
mechanical, including photocopying, without express written permission of Copley Controls
Corporation.
Xenus is a registered trademark of Copley Controls Corporation.
CME 2 is a registered trademark of Copley Controls Corporation.
Windows 95, 98, NT, ME, 2000, and XP, Visual Basic, Excel, and .NET are trademarks or
registered trademarks of the Microsoft Corporation.
LabVIEW is a registered trademark of National Instruments.
Document Validity
We reserve the right to modify our products. The information in this document is subject to change
without notice and does not represent a commitment by Copley Controls Corporation. Copley
Controls Corporation assumes no responsibility for any errors that may appear in this document.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
