54 Operator’s manual @ 601
ERR -7-
Memory damaged or signal lost, calibrate again or
reset.
ERR -8-
The calibration procedure is inappropriate or
the computer or sensor card is damaged, the sensor
connecting line is damaged, the power supply is
not -5v.
WHEEL-HOLDER SHAFT COUNTERWEIGHT
POSITIONING
The counterweight positioning method is widely used in foreign countries. It is applica-
ble to common steel and aluminum alloy rims, in particular to 2000-type new rims, and
ensures high balancing accuracy.
Counterweight positioning procedure:
1) Position the spring with the bottom towards the wheel balancer.
2) Mount a suitable cone.
3) Mount the wheel.
4) Plastic conical ring nut.
5) Quick fixing cap.
To Next Page
Loading...
