Cosmo DN 25 - S1 Service Parameters; Basic Settings

ENG
32
Service settings manual J5060403 v1.2
The contents of service parameters are displayed as follows:
SERVICE PARAMETERS
The desired parameter is changed in the same way as the basic parameters P.
Service parameters are locked and must be unlocked before editing.
Parameter index
Default
parameter
value
- Parameter is locked
Current parameter value
Navigation buttons
Parameter description
Decrease value
Previous position
Increase value
Next position
Cancel
unlocking
Unlock
confirmation
Service parameters are classified into groups S1 - basic settings, S2 - settings for heating
circuit, S3 - settings for heat source.
Setting range
The default unlock code for service parameters is 0001.