Figure 5-61
5.6.8.3 Camera Masking
When someone viciously masks the lens, or the output video is in one-color due to the
environments light change, the system can alert you to guarantee video continuity. Camera
masking interface is shown as in Figure 5-62. You can enable alarm output channel and then
enable show message function. You can refer to chapter 5.6.8.1Motion detect for detailed
information.
Tips:
You can enable preset/tour/pattern activation operation when video loss occurs.
Note:
In Detect interface, copy/paste function is only valid for the same type, which means you
cannot copy a channel setup in video loss mode to camera masking mode.
Figure 5-62
To Next Page
Loading...