Figure 5-68
5.6.11 Default
Click default icon, system pops up a dialogue box. You can highlight to restore default
factory setup.
Select all
General
Encode
Schedule
RS232
Network
Alarm
Detect
Pan/tilt/zoom
Display
Channel name
Please highlight icon to select the corresponding function.
After all the setups please click OK button, system goes back to the previous menu.
Warning!
System menu color, language, time display mode, video format, IP address, user account will not
maintain previous setup after default operation!
5.6.12 Remote Device
Important
Do not connect the switch to the PoE port, otherwise the connection may fail!
5.6.12.1 UPNP
Please connect the IPC to the PoE port of the device rear panel (Figure 5-69), system can auto
connect to the network camera. Please note the following figure is for reference only.
Figure 5-69
5.6.12.2 Built-in Switch Setup
To Next Page
Loading...