Enable alarm activation function. You need to select alarm output port
so that system can activate corresponding alarm device when an
alarm occurs.
For 6-ch alarm output port device, the 6
th
channel is the controllable
+12V output.
System can delay the alarm output for specified time after alarm ended.
The value ranges from 10 seconds to 300 seconds.
System auto activates current channel to record once an alarm occurs
(working with alarm activation function). Please note current device
shall be in auto record mode
System can delay the record for specified time after an alarm ended.
The value ranges from 10s to 300s.
Please draw a circle to enable email function. System can send out
email to alert you when an alarm occurs and ends.
After enabled, alarm info will be prompted out on the local output end.
That is to say, the alarm prompt will be displayed beside the channel
name on the local surveillance image.
Once you check the box here, the buzzer beeps when an alarm
occurred.
Display the selected video in local monitor window. When alarm
occurs, system can begin one-window tour for the activated record
channel. Please set the tour time in the local end.
Here you can set PTZ movement when alarm occurs. Such as go to
preset x when there is an alarm.
The PTZ configuration events include preset, tour, and pattern.
You need to input capture channel number so that system can backup
snapshot file when an alarm occurs.
It is a shortcut menu button. You can copy current channel setup to
one or more (all) channels.
2.2.9.1 Detect
By analyzing video image, system will boot video detection alarm when it senses the motion
signal which meets the senility standard that is previously set. See Figure 7-41.
To Next Page
Loading...