CP Plus CP-UNR-1xxQ1 Series - Page 147

139
Parameter
Function
Period
info.
Channel
Select a monitor channel .
Setup

In NAS interface, click set button, you can go to the
corresponding setup interface. See Figure 7-33.

.Please set schedule period and then select
corresponding record type: schedule/alarm. Please
note device does not support motion detect record
function now.

Please select date (Current setup applies to current
day by default. You can draw a circle before the
week to apply the setup to the whole week.)

After complete setup, please go back to Figure 7-28
and then click save to save current time period
setup.
Copy
User can use this shortcut to copy the storage state of a
channel to another (or all other channels)
NTP
The NTP interface is shown as in Figure 7-34.
Here you can realize network time synchronization. Please enable current function and then input
server IP, port number, time zone and time.
Figure 7-34 NTP
Please refer to the following sheet for detailed information.
Parameter
Function
Enable
Enable NTP function or not.
Server IP
Server IP address
Port
Server port. System supports TCP only and default port value
is 123.