39
• [AE Sensitivity] To set auto exposure sensitivity level, value range 1 to 10. By default value is 5.
• [Auto Iris] To enable or disable auto Iris feature.
• [Automatic Gain] To enable or disable auto gain control of camera, user can also set the upper
limit of AGC from 0 to 100. Default value is 50.
• [WDR] For the WDR scene, this function can lower the high bright section and enhance the
brightness of the low bright section. So that you can view these two sections clearly at the
same time. User can set upper limit of WDR, value ranges from 0 to 100. Default value is 50.
• [Defogging] To enable or disable defogging mode of camera. User can also set the grade for
defogging; value ranges from 0 to 100. Default value is 50.
• [Corridor Mode] To enable or disable corridor mode of camera. This feature is depending of
camera feature.
• [Slow Shutter] To choose No, weak, in or strong.
• [Day noise Level] To set noise level in day time, value range from 0 to 5. Default is 3.
• [Night noise Level] To set noise level in day time, value range from 0 to 5. Default is 3.
• [Mirroring] It is to switch video up and bottom limit. This function is disabled by default.
• [Anti-Flicker] To enable or disable anti-flicker in the fluorescent light.
• [Overturn] To enable or disable overturn.
• [IR Swap] To enable or disable IR in day or night.
Important Note – In Camera page add IP device, Channel status and IPC parameter option will show
or hide according DAC mode.
4.1.2. Event
4.1.2.1. Motion Detect
By analyzing the video image, when the system detects a mobile signal, motion detection alarm is
initiated, and the linkage functions. See Figure 4.13
Note: The front-end equipment and this equipment need to enable this feature. Advanced button
same to the right mouse button.
Motion detection function of mixed mode / full analog and digital channels are different: motion
detection alarm digital channels only to turn its function at the local end, the corresponding remote
device connected to the end of the channel will have motion detection feature is turned on, when
the remote device side corresponding channel has motion detection scene occurs, the local side will
be able to achieve its alarm function, otherwise the motion detection function cannot be achieved,
while the analog channels open as long as the local end manufacturing mobile phenomenon on the
line.
To Next Page
Loading...
