43
Figure 4.17
Digital channels cannot be used to set the sensitivity. Which is a mixed-mode or full simulation mode
can set the sensitivity. Sensitivity level is divided into six kinds, namely: minimum, low, medium,
high, very high, the highest.
Setting method: Please refer to chapter 4.1.2.1.
4.1.2.3. Video Loss
When the device cannot get channel video signal, the video loss alarm, and the linkage function. See
Figure 4.18
*Same with motion detection, the Mixed-mode / full analog and digital channels of video loss
function differently.
Figure 4.18
Video loss alarm configurations please refer
to chapter 4.1.2.1.
Note – By default Video loss function enable for all channel.
To Next Page
