©2016 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com
63
User Manual / AER2100
4/19/16
• Receive version: Select the RIP version that will be accepted on this interface, overriding the global
setting. Version can be 1 or 2, or 0 to select both.
• Passive:
not sent out of, the interface.
• No split horizon: Disable the split horizon mechanism. Enabling prevents RIP from advertising routes over
• Distribute Access-list In/Out:
routes.
• Distribute Prex-list In/Out:
routes.
Neighbors
cases, not all routers will be able to understand multicasting, where packets are sent to a network or a group
IP address.
Redistribute Routes
• Type
• Metric
network information is received. The metric for redistributed routes is set to 1.
• Route Map
applied to routes.
RIP
RIPng (RIP next generation) extends RIPv2 to support IPv6. See RIPng on Wikipedia and RFC 2080 for details.
RIPng Editor
• Name
• Metric
the RIP service increments the metric when the network information
is received. The metric for redistributed routes is set to 1.
• Enabled
Networks
addresses. RIPng is enabled on the interfaces that have addresses within
the network range.
Routes
address.
Redistribute Routes
• Type
• Metric
when the network information is received. The metric for redistributed routes is set to 1.
To Next Page
Loading...
