15
BASIC CONTROLS
The basic controls of this machine are
shown in the figure below. Use the figure
and read the text to understand what the
basic controls of this table saw are.
Figure-15 Basic Controls of the saw
A. Fence Cam Lock: To lock the fence in
position on the rails.
B. Blade Tilt Hand Wheel: To adjust the
blade tilt, unlock the lock on the hand
wheel and turn the hand wheel to set
the blade to the desired tilt position and
re tighten the lock.
C. Blade Height Hand Wheel: To adjust the
blade height, unlock the lock on the
hand wheel and turn the hand wheel to
the desired height and re tighten the
lock.
D. Magnetic Switch: The magnetic switch
with on/off buttons turns the motor on
and off.
TEST RUN
Once you have assembled your machine
completely, then it is time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates strangely, stop the
machine immediately and disconnect from
the power source and investigate if you can
find out the problem with your machine.
If you find out any part of the machine that
is not assembled properly, read the
assembly section of manual and
reassemble that part according to the
instructions provided in the manual.
Before starting the table saw, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
Read the
manual
To Next Page
Loading...
Need help?
General
