19
Position the miter gauge back into the slot
and hold the work piece against the mitre
gauge. Slide the mitre gauge and feed the
work piece into the blade so that the blade
cuts the waste side of the work piece.
MAINTENANCE
1. Clean off any preservative on the saw
components with mineral spirits and
wipe dry.
2. Avoid getting any of the cleaning
material on rubber parts as it may
permanently damage them.
3. Use a mild soap and warm water on
plastic or rubber parts.
4. The unpainted components such as the
precision-ground cast-iron table top
should be protected with a coat of paste
wax and then buffed dry.
5. Regularly vacuum all sawdust from the
saw’s interior and vacuum the motor
openings as well.
6. Lubricate the trunnion and worm gears
with quality white grease on a regular
basis.
7. Lubricate all moving parts, internal
bearings and wear surfaces being very
careful not to allow any lubricant to
come in contact with areas where wood
will contact.
8. Check drive belts for wear and correct
tension on a regular basis.
9. Check that the blade guard and anti
kickback pawls operate properly.
WARNING
Always make sure the blade guard is
installed on your table saw and is in
down position. Failure to do so may
result in serious personal injury.
WARNING
Do not make any adjustments while the
machine is running. Turn off the
machine and un-plug from the power
source before making any adjustments.
To Next Page
Loading...
Need help?
General
