Crane Refreshment Center 784 - Select Bill Validator and Options

Page 11
SNACK/REFRESHMENT CENTER PROGRAMMING GUIDE
1670002
April, 1999
SELECT BILL VALIDATOR AND OPTIONS
1. Press , then press until one of the following is displayed:
NO DBV - No bills will be accepted or there is no bill validator
installed (you can exit the function).
SER.1.2.5.10.20 - The serial bill validator is selected and will accept
$1, $2, $5, $10, and $20 bills. Use BILL SELEC-
TION METHOD below to change the bills which will
be accepted.
MDB.1.2.5.10.20 - A standard MDB bill validator is selected. It will
accept $1, $2, $5, $10 and $20 bills. Use BILL
SELECTION METHOD below to change the bills
which will be accepted.
BILL SELECTION METHOD:
The standard $1, $2, $5, $10 and $20 bills are
enabled by pressing the 1, 2, 5, 6, or 7 key(s),
respectively, to display which bill(s) will be
accepted.
MDB. <
*
> - An MDB bill validator which accepts non-standard
bills or tokens is connected and operating. Press
to enter list of bills. (See INITIAL SETUP
OF NON-STANDARD BILL VALIDATOR on the
following page.)
BILL LIST OPERATION:
Use and to scroll through the list of
bills.
Use to turn the bill acceptance ON or OFF.
Use to move up to the top level screen.
1. 1.00 ON - 1. = Bill validator channel 1, each
bill has its own channel
1.00 = Bill value
ON = $1.00 bill will be accepted