Creality CR-10 Series User Manual

1、Preheat
Method 1
Method 2
2、Feed Filament
Press and hold the extruder lever then insert the 1.75mm filament
through the small hole of the extruder. Continue feeding until you see filament
come out of the nozzle.
Tip：How to Replace the Filament？
1、Cutting filament near the Extruder and slowly feed new filament until the
new filament get into the PTFE tube
2、Preheating the nozzle,Press and hold the extruder, extract the filament,
then feed the new filament.

06/
Loading Filament

Creality CR-10 Series Specifications

General

Build Volume	300 x 300 x 400 mm
Layer Resolution	0.1-0.4 mm
Filament Diameter	1.75 mm
Connectivity	SD Card, USB
Bed Temperature	Up to 100°C
Power Supply	110V/220V, 360W
Nozzle Diameter	0.4 mm (can be replaced with other sizes)
Supported Materials	PLA, ABS, PETG, TPU
Display	LCD
Frame Structure	Aluminum frame