Creality CR-6 SE - Load Filament

Tips： How to Replace the Filament？
1、Cutting filament near the Extruder and slowly feed new filament until they are fed into the new filament.
2、Withdrawing the filament quickly and feeding the new faliment after nozzle preheated and filament pushed a little forward.
Tips：如何更换耗材？
方法一、在靠近挤出机处将耗材剪断，将新耗材缓缓送入，直到耗材被送入导料管为止。
方法二、预热喷嘴后，将耗材往前推进一下后，迅速抽出耗材，将新耗材送入。
When the current temperature reaches the target temperature, the consumables pass the material breakage detection, and are inserted into the small
hole of the extruder until the position of the nozzle. If the consumables flow out at the nozzle, it means that the consumables have been loaded.
当前温度达到目标温度时，将耗材通过断料检测，插入挤出机小孔直至喷嘴位置，看到喷嘴处有耗材流出即表示耗材已经装载完成。
10
Load Filament
Tips： How to Replace the Filament？
1、Cutting filament near the Extruder and slowly feed new filament until they are fed into the new filament.
2、Withdrawing the filament quickly and feeding the new faliment after nozzle preheated and filament pushed a little forward.
Tips：如何更换耗材？
方法一、在靠近挤出机处将耗材剪断，将新耗材缓缓送入，直到耗材被送入导料管为止。
方法二、预热喷嘴后，将耗材往前推进一下后，迅速抽出耗材，将新耗材送入。
11
装料
Before Load Filament
装料前
Load Filament completed
装料完成