Tips: 1. The printing platform is not easy to bend too large in daily use, and it is impossible to prevent deformation from being unusable;
2. The printing platform is a perishable part, and it is recommended to replace it regularly to ensure that the first layer of the model sticks properly.
6.Equipment Maintenance
6.1 Platform plate removal and maintenance
18
6.2 Maintenance of screw rod, optical axis and guide rail
It is recommended to purchase lubricant and perform regular lubrication maintenance on the screw rods, optical shafts, and guide rail areas.
② If there are residual filaments on the
platform plate, scrape them off lightly
with a blade and print again.
③ If the first layer of the model is not
properly glued, it is recommended to
apply solid adhesive evenly on the
surface of the platform plate .
① a. When printing is finished, wait for the platform plate to
cool before removing the printing platform with the model
attached;
b. Slightly bend the platform with both hands to separate
the model from the platform.
Screw rod area
Optic axis and guide rail area
Guide rail area
Optical axis area
To Next Page
Loading...
Need help?
General
