Routine Maintenance
- 35 -
Using skills
Change Fuse
Open fuse tray
Change new fuse
1. Frequent cleaning stains on the rail.
2. Lubricate the four guide rail.
3. Frequent cleaning feeder gear.
Notice: Don’t add too much lubricating
oil.
Print Setting Of Different Filament
* The data is only for reference, different environmental data will be different.F160 and F430 can print PEEK.
Add Multi Type Printer
You can add more than one type of
CreatBot to the software, and easily
switch between them without re-config
all the different machine settings.
- 34 -
F430
Software Operation
Using skills
To Next Page
