Crestron PRO3 Reference Guide

Reference Guide – DOC. 7150B 3-Series Control Systems • 31
Remote System Logging
Control system messages can be captured and stored on a remote server using
the remote system logging function.
NOTE: The remote server host must have system log server with the applicable
security certificates and sufficient disk space to store the active system log. The
host should also be configured to archive older system logs and to off load them
over time. If TLS is enabled, a TLS-enabled server with the appropriate
certificates is required.
To configure remote system logging, issue the REMOTESYSlog command.
• Syntax: REMOTESYSlog [-S] {-E} {-A} [-I:address] [-P:port]
{-T:protocol} {-V:ON|OFF}
o -S:[ON|OFF]: Enables or disables remote system logging
o -E:[level]: Logs all messages at the provided error level and above.
The default setting is “Notice.”
 OK
 Info
 Notice
 Warning
 Error
 Fatal
o -A: Appends the contents of the audit log to the system log
NOTE: Audit logging must be turned on to use this feature. For more
information, refer to "Audit Logging" on page 32.
o -I:address: Sets the remote server IP address for the system log in
dot decimal notation or as an ASCII string containing the server host
name (maximum 255 characters)
o -P:port: The remote server port number in decimal notation
o -T:protocol: The protocol used to connect to the remote server
 TCP
 UDP
 SSL
o -V: If SSL is enabled, set to ON to require server verification or set to
OFF to not require server verification.
o No parameter: Displays the current setting
• Example: REMOTESYSlog -S:ON -E:NOTICE -A -I:255.255.255.255
-P:12345 -T:SSL -V:OFF
Remote system logging can also be configured in Crestron Toolbox using the
Syslog function. For more information, refer to the Crestron Toolbox help file.

Crestron PRO3 Specifications

General

Brand	Crestron
Model	PRO3
Category	Control Systems
Language	English