EasyManuals Logo

Crestron PRO3 Reference Guide

Crestron PRO3
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
40 3-Series Control Systems Reference Guide DOC. 7150B
Run Multiple Programs
3-Series processors run multiple programs simultaneously to allow programmers
to independently develop and run device specific programs for AV, lighting,
HVAC, security, and so forth. As a system grows, processing resources can easily
be shifted from one 3-Series processor to another without rewriting any code.
Device Registration Considerations
To keep the system running seamlessly, consider the following when stopping and
starting programs:
To ensure that devices are registered by the correct programs, note that
programs restart in ascending order by program slot when the device is
rebooted or when the PROGreset command is entered. For example,
Program 1 starts before Program 2.
Since most devices can only be registered by a single program, the first
program to try registering the device succeeds; subsequent attempts to
register the device fail. If Program 1 registers a device, then Program 2 is
not able to register it.
NOTE: This behavior does not apply when programs are started and
stopped individually. For example, if the programmer stops all programs
and restarts Program 10 before Program 1, Program 10 registers the
device first.
There are exceptions to this rule, as some devices, slots, and ports can be
registered by multiple programs. Refer to the following table to
determine whether a particular control system slot or port is exclusive
(can only be registered by one program) or shareable (can be registered
by multiple programs).
3-Series Port and Slot Sharing
SLOT OR PORT STATUS
3-Series Ethernet card
cages
Sharable
BACnet Exclusive
Built-in audio slot Sharable
Built-in COM ports
Slots are sharable but ports are exclusive (For example,
Program 1 can register COM 2 while Program 5 registers COM
1, but both programs cannot register COM 2 at the once.)
Built-in digital inputs Slots and ports are sharable
Built-in on screen display
Sharabl
e, although each program must define its own specific
device ID as a parameter on the symbol
Built-in relays Slots and ports are sharable
Built-in RF gateway Slots are sharable but individual devices are exclusive
Built-in system monitor Sharable
Built-in Versiports
Slots are sharable, ports are sharable only if they have the
same configuration

Other manuals for Crestron PRO3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Crestron PRO3 and is the answer not in the manual?

Crestron PRO3 Specifications

General IconGeneral
BrandCrestron
ModelPRO3
CategoryControl Systems
LanguageEnglish

Related product manuals