Reference Guide – DOC. 7150B 3-Series Control Systems • 43
Master-Slave Configuration
Use the following console commands to configure master-slave mode
parameters for the control system.
Add Master Entry
To add a master entry to the IP table, use the ADDMASTER command.
• Syntax: ADDMASTER [cipid] -[ip_address/name]
o cipid: The ID of the CIP node (in hexadecimal format)
o ip_address/name: The IP address (in dot decimal notation) or the
name of the site for DNS lookup
• Example: ADDMASTER 1E -PRO3-IH
Remove Master Entry
To remove a master entry from the IP table, use the REMMASTER command.
• Syntax: REMMASTER [cipid] -[ip_address/name]
o cipid: The ID of the CIP node (in hexadecimal format)
o ip_address/name: The IP address (in dot decimal notation) or the
name of the site for DNS lookup
• Example: REMMASTER 1E -PRO3-IH
View Master IP Table
To view the master IP table, use the MIPTABLE command. Append [-T] to the
command to output the results in table format.
View Slave Status
To display the status of the slave processor, use the SLAVESTATUS command.
To Next Page
Loading...
Need help?
General
