EasyManuals Logo

Crestron PRO3 Reference Guide

Crestron PRO3
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
50 3-Series Control Systems Reference Guide DOC. 7150B
Refer to the following best practices to manage the system properly:
Cresnet and EX devices on the internal gateway can be safely updated
when using "wildcards" for the controller hostname.
If updating Ethernet devices, it is recommended to specify device IDs so
that the controller can be selective when updating.
o The statement above assumes that the system is configured and that
the IP table is set up correctly on the Ethernet devices. It also assumes
that the devices follow the auto-discovery specification.
o The above statement might not work for a first-time setup.
If updating peripherals connected to an Ethernet-connected gateway or
bridge, the user is responsible for managing the manifest file.
Control System Update Parameters
On a control system, a combination of "deviceId" and "deviceModel"
indicates what device needs to get updated. The "deviceModel" always needs to
be specified, since this parameter indicates the class of device and the
corresponding plugin that handles the update. If "deviceId" is set to "any", all
devices of the type specified by "deviceModel" will be updated.
DeviceId
Multiple devices that share the same type are often connected to the same
control system. In this case, all of these devices can be updated using the "any"
keyword. A single device can be updated using its specific device ID. If multiple
device IDs need to be updated, multiple sections must be created in the manifest.
To support this schema, the control system accepts a range and/or a list of the
devices, which can be specified as follows:
List: A comma separated list (3,4,78,95)
Range: A continuous range of device IDs (5-15)
List and Range: A combination of the above two (3,73,25, A-1E)
NOTE: The device IDs must be in hexadecimal format with no preceding
"0x".

Other manuals for Crestron PRO3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Crestron PRO3 and is the answer not in the manual?

Crestron PRO3 Specifications

General IconGeneral
BrandCrestron
ModelPRO3
CategoryControl Systems
LanguageEnglish

Related product manuals