Crestron TS-70 Series - Page 138

134 • TS-70 Series Product Manual — Doc. 8555F
l
Display Edge:Select a radio button (Top, Bottom, Left, or Right)to select the position on
the touch screen where the virtual toolbar is displayed.
l
Auto Hide Timeout:Select a duration (in seconds)that must elapse before the virtual
toolbar is hidden automatically.
Select the + (plus)icon next to PinPoint Beacon to display the following Bluetooth beacon
settings.
Settings Tab - System Setup (PinPoint Beacon)
l
BTEnabled:Turn on the toggle to use the Bluetooth beacon.
l
BTMode:Use the drop-down menu to select the mode (Advertise or Config)of the
Bluetooth beacon.
o
Select Advertise to make the Bluetooth beacon available to Crestron devices that
support this functionality.
o
Select Config to put the Bluetooth beacon into configuration mode.
Services
Select Services to configure Crestron Fusion® software settings.
Settings Tab - Services
NOTE: If connecting to a Crestron Fusion software on-premises server, connections are
made using either traditional (outbound) or inbound communications. For more information,
refer to the Crestron Fusion 10 On-Premises Software Getting Started Guide.
l
Crestron Fusion Cloud: Turn on the toggle to allow a connection to a Crestron Fusion
Cloud server. This connection is only applicable when the scheduling mode is set to
Crestron Default or User Project.
l
Crestron Fusion Cloud URL: Enter the URL used to connect the touch screen to the desired
Crestron Fusion Cloud server.