SG250 Ownerās and Service Manual
www.CSCMotorcycles.com
10
when the low beam is on. You can use it to alert a vehicle you are about to pass. The high beam/low
beam switch is used to switch between the high beam and low beam. The turn signals are activated
when the turn signal is pushed either to the right or to the left. The turn signals are not self-cancelling;
you must depress the turn signal switch sharply in its center position to turn the turn signal off. The
horn button sounds the horn.
Right handlebar switchgear includes the engine kill switch and the starter switch. The kill switch is used
to shut all electrical power to the motorcycle. Do not routinely use the kill switch to stop the engine
(use the ignition switch instead). The starter switch is used to start the engine after the ignition switch is
turned on.
Fuel, Fuel Tank, Filler Cap, and Petcock
The SG250 fuel tank holds 4.0 gallons of fuel. Use 87 octane or higher fuel.
The fuel petcock is located on left side of the tank. Turn the petcock to the OFF position when you are
not riding the motorcycle. Turn the petcock to the RUN position prior to operating the motorcycle. If
the motorcycle runs out of fuel, turn the petcock to the RESERVE position. Find a fuel station and fill
the motorcycle as soon as possible after the fuel petcock switching to the RESERVE position.
The fuel tank filler cap is a locking cap. To open it, insert the ignition key in the fuel tank and turn it
clockwise. After filling the fuel tank, push down firmly on the filler cap to lock it.
To Next Page
Loading...
