SG250 Owner’s and Service Manual
www.CSCMotorcycles.com
95
If any of the cells are below the minimum level, remove the
filler cap for each affected cell. Add only distilled water to a
cell if it is below the minimum level such that the cell level is
within the acceptable range.
We recommend replacing the battery if it is more than 2
years old, or if the battery won’t hold a charge.
Evaluate the battery’s ability to hold a charge by leaving it on
the charger long enough to fully charge, and then measure
the voltage. If it’s less than 12.8 volts, replace the battery.
If you need a new battery, CSC stocks all of the parts for your
SG250. Please call us at 909 445 0900.
We recommend using a trickle charger, and we use the
Battery Tender brand. If you want one, please call us at 909
445 0900.
Lighting and Turn Signals
This section of the Owner’s and Service Manual addresses the motorcycle’s lighting, including the
headlight, the taillight and brake light, the instrumentation lights, and the turn signals.
If you experience a lighting failure, the most likely cause of failure is the bulb or, in the case of the turn
signals, the turn signal lights. Check the bulb for the light that is not working first. If the bulb is open
or not operating correctly, you will need to replace this component. If the bulb is intact and
operational, the fault lies elsewhere and you will need to find the source in the circuit leading to the
bulb. The procedure for replacing the headlight bulb is shown here; the procedure for replacing other
lights is similar.
To Next Page
Loading...
