CSC SG250 - Front Brake Rotor Inspection

SG250 Owner’s and Service Manual
www.CSCMotorcycles.com
23
Remove the rear axle nut and remove the rear axle.
Caution! Support the rear wheel when removing the rear axle.
Remove the brake plate from the rear wheel to inspect the
brake shoes. When they are worn beyond the range allowed
for adjustability of the brake actuation rod (see above),
remove and replace both shoes.
The brake shoes are removed by rotating them away from
the brake plate, as shown here.
CSC stocks replacement brake shoes, so call us at 909 445 0900 if you need to order a pair.
Note that it is normal for the front brake pads to wear out much more quickly than the rear brake
shoes.
Assembly is the reverse of disassembly.
Front Brake Rotor Inspection
The front brake rotor is 4mm thick when new. When rotor
thickness drops below 3mm, the rotor should be replaced.